![]() ![]() (This sometimes helps with stability issues) Optionally disconnect and power down the CM1 with a 2 minute wait between powering up and reconnecting the USB cable. The 'shortfin_dcmwd4e' files should be listed. When successful, the command will return without reporting an error. In the VM window, select 'Devices' -> 'USB Devices' and enable 'FTDI Cairnsmore1 ' and the device for your USB drive.ĭepending on how your USB drive is formatted you will need to use a variation of the following command to 'mount' the filesystem. Wait 2 minutes and then reconnect the USB cable. Please read 'Cairnsmore1_Controller_Upgrade_Procedure.pdf' from 'CAIRNSMORE1_CONTROLLER_SHARING_V1_5.zip' for more detailed information.Ĭonnect the PSU. If errors occur DO NOT POWER DOWN - re-run the command. Once complete with no reported errors, disconnect the USB cable and then the PSU. The terminal should show the following output: SPIProg.exe CAIRNSMORE1_CONTROLLER_REV_1_5.bit ![]() Right click to check the properties of each COM port and note down the ones that correspond to Cairnsmore 1 Port A
0 Comments
Leave a Reply. |